More InformationMulti-Function FT2232H Development Board
FT2232H chip ，channel 1 can be used for JTAG， channel 2 can be used for UART, SPI, I2C etc
High speed USB 2.0 interface
Uses ARM’s standard 2×10 pin JTAG connector
Supports targets working in voltage range 1.8 – 5.0 V DC
FT2232H reset button included.
Target board system reset button
Dual AT93c56 chip (eeprom) is switched by jumper. This feature is very useful for developers, not only can avoid the eeprom burning failure, the development board can not be used, but also make this development board into two development boards, just selected by jumper.
JTAG (channel 1), UART (channel 2) simultaneous output
Channel 2 can be programmed by the user as spi, i2c, etc.
Dimensions 10.2x5.4 mm (2×1.6″)， 15 cm (8″) 2×10 JTAG cable ribbon cable included，
Optional accessories: 6pin, 2×7 pin adapter plate, 15cm 1×6 cable, 2×7 cable, housing
This Ad has been viewed 108 times.